Solid and Sponge Self Supported Connectors

The Solid Self-Supporting ZEBRA® connector utilizes a standard ZEBRA® connector element supported by a soft, non-conductive silicone rubber on one or two sides. The silicone rubber creates a larger width that eliminates the need for a holder, and yet the force required for deflection is very low. The standard Solid Self-Supporting ZEBRA® connector has a 0.020”/0.50mm wide ZEBRA® connector element and is available in 8 different widths to accommodate LCD’s with a glass lip overhang of 0.050”/1.27 mm minimum.

Solid and Sponge Self Supported Connectors
Sponge Self Supported Connectors

The Self Supporting Sponge ZEBRA® connector utilizes standard ZEBRA® connector elements supported by a silicone sponge rubber on one or two sides. The silicone sponge creates a larger width that can eliminate the need for a holder, and yet the force required for deflection is very low. The standard Self Supporting Sponge ZEBRA® connector is available in a host of widths to accommodate LCD’s with a glass lip overhang of 0.060”/1.5 mm minimum. The Self Supporting Sponge ZEBRA® connector is used to connect LCD’s to printed circuit boards and eliminates bowing of the printed circuit board due to the low force required to make contact.

Sponge Self Supported Connectors
DescriptionInsulating Barrier
Color (one only)White
Hardness, Durometer A30
Dielectric Strengtd volts/mil.500
Resistance, ohms1012
Insulating Barrier Widtd (B) in.*
(B) mm
0.002 ± 0.001
0.050 ± 0.025

TABLE D *The tolerance of W1 is equal to the sum of the tolerances of W.

The tolerance of W1 is equal to the sum of the tolerances of W.
Part Number and Nomenclature:

To specify a connector to your exact requirements, substitute the metric measurements for width, length and height according to instructions below; example part# Ag(2.0 IB1 x 20 x 2.0)-U;

Part Number and Nomenclature
Fujipoly: Thermal Interface Materials

Solid and Sponge Self Supported Connectors

ISO 9001:2015